Tired of your rigid, clumsy measuring tape scratching a pristine paint job or snapping right in the middle of a crucial measurement? We were too. That's why we built the TeckWrap Soft Fiberglass Measuring Tape, the tool that finally bridges the gap between precision and paint protection. Your vehicle's finish is everything. This tape is crafted from a uniquely soft PVC-coated fiberglass material that glides over curves and contours without leaving a single mark. Get the exact measurements you need for that flawless vinyl wrap with absolute peace of mind for both your hands and the vehicle's factory paint. With more than double the tensile strength of standard PVC tape, it refuses to snap or stretch under pressure, delivering consistent accuracy from the first measurement to the thousandth. What makes the TeckWrap Soft Fiberglass Measuring Tape stand out: Soft PVC-coated fiberglass, scratches no paint on cars, mirrors, or interior trim Doubled tensile strength, won't snap or stretch under pressure Dual-scale dual-side reading: metric (mm/cm) and imperial (inches) Foldable high-strength resin crank handle, compact and tool-bag friendly Rugged stainless-steel case with smooth retraction mechanism Reinforced stainless-steel rim, impact and drop resistant Fully waterproof and rust-resistant for shop, garage, or location work Resists deformation, accurate after hundreds of fold cycles Lightweight at 158 g, palm-friendly compact case Ideal for professional vinyl wrap installers, PPF specialists, detailers, body shops, and serious DIYers who measure curved surfaces, body panels, mirrors, and full vehicles. Built for the demands of a wrap shop where speed, accuracy, and paint protection matter equally. Order now. Backed by TeckWrap's decade of vinyl wrap and PPF manufacturing experience and worldwide installer network.

Film Construction

• Film Type: Tools
• Film Thickness: product-specific
• Release Liner: product-specific
• Adhesive: product-specific
• Roll Width: product-specific
• Full Roll Length: product-specific

Performance

• Service temperature: product-specific
• Release force: 0.18 N/25mm (standard 0.10-0.30)
• Initial tack: 1015 g/25mm (standard 800-1500)
• Peel strength (180°): 8.1 N/25mm (standard >=4.9)
• Adhesion strength: 70 (standard >=60, no shifting)
• Aging tested: high and low temperature release without adhesive residue
• Storage shelf life: 2 years at +10°C to +20°C, 50% RH, dry conditions, away from sunlight

Warranty

• Warranty and use conditions depend on the specific item.

• Application temperature: product-specific
• Tools: squeegee with buffer, knife, masking tape, heat gun, magnets, gloves, IR thermometer
• Conformability: consult product use before application
• Post-heat: product-specific
• Cure: product-specific
• Overlap: 3-4 mm
• Non-directional film.
• Clean, degrease, and dry the surface before installation.
• Remove the protective cap or PET protective layer before applying heat.
• Aftercare: use pH-neutral products and avoid hot wax or strong solvents.

TeckWrap statements, technical information, and recommendations are based on product testing believed to be reliable, but they do not guarantee identical results in every installation environment. The buyer should confirm suitability for the intended vehicle and use.

Screen images may vary from the physical film. Always check a real color swatch before ordering, and use rolls from the same production LOT for full-wrap color consistency.

Film performance depends on storage, surface preparation, installation method, climate, and maintenance. Scratches during installation or daily use, labor, transportation, and consequential damages are not covered by standard product warranty.